Angle Flange U-Trough is the most commonly employed U-Trough.  The top flange is fabricated with heavy duty structural steel angles welded flush with the top housing edge.  End flanges are jig welded to insure proper alignment with other trough sections.

Formed Flange U-Trough top flange is formed from the same sheet as the trough, resulting in a lightweight yet rigid housing section.  End flanges are jig welded for perfect alignment with other sections.

Channel U-Trough is well suited for applications requiring long distances between conveyor supports.  Upper trough sides are fabricated with structural steel channels to which the lower contoured section may be bolted or spring clamped.  Channel U-Trough is useful for abrasive applications where frequent replacement of the lower formed section is anticipated.

Drop Bottom U-Trough is intended for applications where quick convenient access to the conveyor interior is required. The drop bottom trough consist of rigid upper side channels to which a lower contoured section is attached.  One side of the lower formed section is hinged while the other is attached by use of spring clamps or other type of quick opening device.

Jacketed U-Trough consists of a U-Trough and continuously welded steel jacket which forms a chamber between the inner and outer walls for heating or cooling media.  Built to specifications to suit individual requirement.

Formed Flange Flared Trough top flanges are formed from the same sheet as the housing.  End flanges are jig welded for perfect alignment with other sections.

Standard Tubular Troughs are inherently dust tight, weather tight, rigid and may be readily loaded to a full cross section.  The standard tubular housing is rolled form a single sheet and continuously welded at the seam.

Angle Flanged Tubular Trough consist of semicircular formed halves, each of which includes an angle flange of structural steel.  The two sections are bolted together to form the tubular housing.

Formed Flange Tubular Trough is similar to the angle flanged except that the flanges are formed from the same sheet as that of the contoured half sections, thus resulting in a rigid, lightweight tubular section.  The halves are bolted together to form the complete housing.

Angle Flange Rectangular Troughs are well suited for highly abrasive applications.  The material is allowed to form on the trough bottom, thus preventing abrasion directly against he housing wall.  Top flanges are fabricated of structural steel angle welded flush with the top housing edge.

Formed Flange Rectangular Troughs top flange is formed from the same sheet as the trough, thus providing a rigid lighter housing.

Screw Conveyors

Online Catalogs

Drag Conveyors

Conveyor Album

Bucket Elevators

Index Page

Belt Conveyors

NCI  Home

Conveyor Screws

Sales Reps Wanted

Phone 817-558-1768

E-mail

Fax 817-558-2219

Mail To:

Newton Conveyors, Inc.

P. O. Box 816

Cleburne, Texas 76033

Deliveries:

Newton Conveyors, Inc.

1204 C. R. 1123

Cleburne, Texas 76033