|
|
|
|
|
|
|
|
Flanged Covers
|
|
|
|
Flanged covers are turned down approximately 3/4" on each side. Flanges provide a limited degree of weather and dust proofing and also may be gasketed for more complete dust or non critical
weather proof operation. They are secured by means of bolts, screw clamps or toggle clamps. |
|
|
|
Flat Covers |
|
|
|
Flat covers fit flush with housing top flanges. They may be attached with bolts, spring clamps, screw clamps or toggle clamps. Although flat covers are intended primarily for interior
applications, they also mat be gasketed for moderate dust proof operation. |
|
|
|
Flared Trough Covers |
|
|
|
Flared trough covers are similar to standard flanged covers except that they are fabricated specifically for flared troughs. They may be bolted or fastened with screw clamps or toggle clamps. |
|
|
|
Hip Roof Covers
|
|
|
|
Hip roof covers are designed for outside applications. The center peak of the cover sheds rain or snow. Both sides of the cover are flanged to provide additional weather
proofing. These covers also may be gasketed for more severe weather proof operation. Covers may be bolted or attached with screw clamps or toggle clamps. |
|
|
|
Shroud Cover |
|
|
|
A shroud cover is designed for use with standard U-Trough when a tubular cross section is required. Standard covers frequently are used with the shroud cover to prevent accumulation of
foreign matter or moisture in the pockets formed by the contour of the shroud and the sides of the housing. |
|
|
Domed Covers |
|
|
|
The domed cover is intended primarily for applications where fumes or heat must be vented from the housing. Ventilation lines are readily attached to this type cover. The domed cover
is built to specifications to suit individual requirements. Specific applications should be referred to the Engineering Department. |
|